Instruction manual

44
Orion Installation and Operations Manual
Selecting the Color Depth
Color Depth
JP3
16 / 24 Bit AutoSelect
Color depth depends on frame
contents (Default)
24 Bit
Set-up Remote Unit
Selecting the moment of switching to the next frame
The transmission of screen data is not synchronous to the screen change of the graphic card. Normally, the
transmission is terminated when a frame is displayed on the screen. If the device switches to the new frame during
HSYNC, the displaying period of the old frame, you may see horizontal screen breaks at the moment of switching
(default). Alternatively, you can set up the units to idle until the actual frame is displayed completely, during VSYNC.
Using this method, the number of frames per second transmitted is lower.
Remove the upper portion of the remote (receiver) unit chassis and orient the PC board as shown below. Note the
location of jumpers JP1, JP2, and JP3 on the remote unit (Receiver). Set the jumper on JP3 as shown below.
JP1, JP2, JP3
Location
Moment to Switch
JP3
Switching during HSYNC (Default)
Higher frame rate but (possibly) horizontal
breaks detectable
Switching during VSYNC
Lower frame rate, no horizontal breaks
detectable but (possibly) stepping pictures.
JP1, JP2, JP3