Installation Guide

Fleet Gate Installation Guide Roseman Engineering Ltd
17
The Fueling Division of Roseman Engineering Ltd.
Optional Power Supply Connection
It is possible to supply the power to the FG3 from the OBD II
connector as follows:
- Connect Pin 16 to BATT (+) on the FG3.
- Connect Pin 4 to BATT (-) on the FG3.
Slim RF Antenna with
Adhesive
-
Black
BATTERY
12VDC
+
Fuse 3A
IN PUT 2
IN PUT 1
DALLAS LED
IMMOBILIZER
DALLAS IN
(-) BAT OUT
(-) BAT IN
(+) BAT OUT
(+) BAT IN
CAN L (-)
ACC CANBUS
POWER/RF
GPS/GPRS
PROG
GPS
CAN H(+)
DC-EO
VSS
12V / 24V
RID-FG3-03
OBD II CAN BUS Connector Pin Out
Pin 6
Pin 14
Optional- Pin 4
Ignition switch
Optional- Pin 16
GPRS
ROSEMAN
FLEET GATE
Figure 5: Wiring Diagram for FG3 with CAN Bus Interface
for Light Duty Vehicles