Installation Guide

Fleet Gate Installation Guide Roseman Engineering Ltd
18
The Fueling Division of Roseman Engineering Ltd.
5.3.1 Connect the FG3 to a J1939 Connector (Heavy Duty Vehicle)
If the vehicle has a 9 pin Deutsch connector for electronic instrumentation,
perform the following:
Run a twin wire cable from the vehicle connector to the FG3 as follows:
1. Connect the CAN_H Black wire from pin 3/C of the Deutsch
connector to the FG3 point CAN_H.
2. Connect the CAN_L white wire from pin 4/D of the Deutsch
connector to the FG3 point CAN_L.
Note
Optional Power Supply Connection
It is possible to supply the power to the FG3 from the J1939CAB9
connector as follows:
- Connect Pin 2/B to BATT (+) on the FG3.
- Connect Pin 1/A to BATT (-) on the FG3.
Optional - Pin A - J1939CAB9
GPRS
1
.
5
m
e
t
e
r
Slim RF Antenna with
Adhesive
-
Black
BATTERY
12VDC
+
Fuse 3A
INPUT 2
INPUT 1
DALLAS LED
IMMOB ILIZER
DALLAS IN
(-) BAT OU T
(-) BAT IN
(+) BAT OUT
(+) BAT IN
CAN L (-)
ACC
CANBUS
POWER/RF
GPS/GPRS
PROG
GPS
CAN H(+)
DC-EO
VSS
12V / 24V
RID-FG3-03
Ignition switch
Pin C - J1939CAB9
Pin D - J1939CAB9
View into SAE J1939 or
J1708CAB9 Connector
SAE J1939 or J1708CAB9 Deutsch Connector- Pin Out
ROSEMAN
FLEET GATE
Figure 6: Wiring Diagram for FG3 with CAN Bus Interface for Heavy Duty Vehicles