Installation Guide
Fleet Gate Installation Guide Roseman Engineering Ltd
24
The Fueling Division of Roseman Engineering Ltd.
Optional - Pin A - J1939CAB9
GPRS
1.5 meter
Slim RF Antenna with
Adhesive
-
Black
BATTERY
12VDC
+
Fuse 3A
IN PUT 2
IN PUT 1
DALLAS LED
IMMOBILIZER
DALLAS IN
(-) BAT OUT
(-) BAT IN
(+) BAT OUT
(+) BAT IN
CAN L (-)
ACC CANBUS
POWER/RF
GPS/GPRS
PROG
GPS
CAN H(+)
DC-EO
VSS
ROSEMAN
FLEET GATE
12V / 24V
RID-FG3-03
Ignition switch
Pin C - J1939CAB9
Pin D - J1939CAB9
View into SAE J1939 or
J1708CAB9 Connector
SAE J1939 or J1708CAB9 Deutsch Connector- Pin Out
Figure 9: Wiring Diagram for FG3 to J1708CAB9 (9 pin) connector
7.2.2 Connect the FG3 to an J1708 CAB Connector
If the vehicle has a 6 pin Deutsch connector for electronic instrumentation, perform the
following:
Run a twin wire cable from the vehicle connector to the FG3 as follows:
1. Connect the J1708 Data link (+) wire from pin - A of the Deutsch connector.
2. Connect the J1708 Data link (-) wire from pin - B of the Deutsch connector.
NOTE: Optional Power Supply Connection refer to Figure 8.