Installation Manual

3 FJ3 Installation

3.1 Mount the FJ3

1. After reviewing the recommendations listed in 2.1 “Installation Installation Considerations”,

mount the FJ3 as follows:

• If possible, mount it on the same side of the vehicle as the filler neck.

• For a passenger car, the FJ3 can be mounted under the dashboard or in the

trunk, provided that the unit is at least 3 feet from the filler neck.

• For a truck or bus, the FJ3 can be mounted inside the vehicle's electric

enclosure.

2. Drill at least two 1/8" holes for the FJ3 mounting. Use the FJ3 to mark the holes (see Error!

Reference source not found.)

3. Mount the FJ3 on the vehicle chassis, or any other metal portion of the vehicle whenever

possible. (See figure 2)

4. Use min. two 3/8" self-tapping mounting screws and lock washers and mount the FJ3 to the

vehicle chassis/frame.

3.2 FJ3 Connector 20 PIN out

Do not use an electric drill or any other electrical power tool

within 3 feet of the filler neck or fuel tank. This area is

considered a Class I Group D hazardous location.