Manualshelf

Installation Manual

ManualsBrandsRoseman Engineering ManualsAutomotiveCar Data Logger
11121314151617181920
17
5.2.1 Connect the FJ3 to an OBD II Connector (Light Duty Vehicle)
If the vehicle has an OBD II connector, perform the following (if not using the AW OBDII harness):
4. Run a twin wire cable from the vehicle connector to the FJ3.
5. Connect the FJ3 CAN_H pin 12 to pin 6 of the OBD II connector.
6. Connect the FJ3 CAN_L pin 2 to pin 14 of the OBD II connector.
Figure 5: Wiring Diagram for FJ3 with CANBUS OBDII for Light Duty Vehicles