Installation Manual

29
Make sure the wires are plugged in side-by-side
into the connector. Press down on the orange
tabs to insert or release the wires.
8.1.1 Troubleshooting
If the Hardwired FIA wire adapter does not work, do the following:
1. Use the Programmer to try read/verify the FJ3
2. If you cannot read/verify it, ensure that the FIA ring is good and correctly connected.
3. If possible, check the FIA with an Ohm meter, it should read around 50 Ohm, if not replace
the FIA.
4. If still not working, replace the HW FIA wire adapter.
Note
The Fuel Inlet Antenna Connector is a sealed unit and cannot be repaired in
the field. Please return the defective unit to Roseman, if under warranty.
Velcro adhesive
FIA Wire Connections