Installation Manual

1 Introduction

1.1 Purpose

This FuelFocus® Vehicle Subsystem Installation Manual instructs how to install the

Modular Fleet Journal Type 3 (FJ3). Review this manual prior to installing the FJ3.

Incorrect installations may cause the system to malfunction.

Read this entire manual before your first installation.

1.2 System Overview

The Roseman FJ3 is the main component of the Roseman FuelFocus® FMS

System in the vehicle. The following are required to properly install and utilize the

FuelFocus® FJ3:

• Roseman FuelFocus® Fuel Management System Island Controllers (ICU)

• Pumps/dispensers equipped with FuelFocus FJ3/dual mode nozzle tags

• FJ3 WAF Receiver Kit installed on the FuelFocus Island Controller (ICU)

Shielded cable is required, as described in the manual. Failure

to use one will void the warranty.

1.3 Components Overview

This section describes the various components in the Roseman FuelFocus®

System, to determine the equipment needed for your specific fleet of vehicles.

Each Vehicle Unit includes the following components:

• Fuel Inlet Antenna (FIA)

• Hardwired FIA Adapter (if a SVID is not used)

• SVID (Small Vehicle Identification Device) Type 3 (If applicable)

• Modular Fleet Journal Type 3 (FJ3)