Declaration of Conformity
Table Of Contents
- 1 Product certifications
- 1.1 European directive and UKCA regulations information
- 1.2 Safety Instrumented Systems (SIS)
- 1.3 Ordinary location certification
- 1.4 Environmental conditions
- 1.5 Telecommunication compliance
- 1.6 FCC
- 1.7 IC
- 1.8 Radio Equipment Directive (RED) 2014/53/EU and Radio Equipment Regulations S.I. 2017/1206
- 1.9 Installing equipment in North America
- 1.10 USA
- 1.11 Canada
- 1.12 Europe
- 1.13 International
- 1.14 Additional certifications
- 1.15 Installation drawings
- 1.16 EU and UK Declaration of Conformity
- 1.17 China RoHS
LPR (Level Probing Radar)
For a device with ATAP lens antenna (code SCA):
• Install at a separation distance of >4 km from Radio Astronomy sites,
unless a special authorization has been provided by the responsible
National regulatory authority (a list of Radio Astronomy sites may be
found at www.craf.eu).
• Between 4 km to 40 km around any Radio Astronomy site the LPR
antenna height shall not exceed 15 m height above ground.
TLPR (Tank Level Probing Radar)
The device must be installed in closed tanks. Install according to
requirements in ETSI EN 302 372 (Annex E).
Performance under the influence of an interferer signal
For the receiver test that covers the influence of an interferer signal to the
device, the performance criterion has at least the following level of
performance according to ETSI TS 103 361.
• Performance criterion: measurement value variation Δd over time during
a distance measurement
• Level of performance: Δd ≤ ± 1 mm
1.9 Installing equipment in North America
The US National Electrical Code
®
(NEC) and the Canadian Electrical Code
(CEC) permit the use of Division marked equipment in Zones and Zone
marked equipment in Divisions. The markings must be suitable for the area
classification, gas, and temperature class. This information is clearly defined
in the respective codes.
1.10 USA
1.10.1 I5 Intrinsic Safety (IS), Non-Incendive (NI)
Certificate
FM21US0116X
Standards
Class 3810:2021, FM Class 3600:2022, FM Class
3610:2021, FM Class 3611:2021, FM Class 3810:2021,
ANSI/ISA 60079-0:2020, ANSI/UL 60079-7:2021,
ANSI/UL 60079-11:2014, ANSI/UL 60079-26:2017,
ANSI/UL 121201:2019, ANSI/ISA 61010-1:2012,
UL50E:2015, ANSI/IEC 60529:2014, UL122701 Ed 3.
Markings
IS CL I, ll, lll DIV 1, GRPS A-G T4…T2
NI CL I, DIV 2, GRPS A-D T4…T2
S CL Il, lll DIV 2, GRPS E-G T4…T2
September 2022 Product Certifications
Product Certifications 5