Quick Start Guide
Table Of Contents
- 1 About this guide
- 2 Confirm approval type
- 3 Mount the process seal antenna
- 4 Mount the lens antenna
- 5 Mount the ATAP lens antenna
- 6 Rotate the transmitter housing
- 7 Prepare the electrical connections
- 8 Connect wiring and power up
- 9 Configuration
WARNING
Electrical shock could cause death or serious injury.
Ensure the mains power to the transmitter is off and the lines to any other
external power source are disconnected or not powered while wiring the
transmitter.
WARNING
Process leaks could result in death or serious injury.
Ensure that the transmitter is handled carefully. If the process seal is
damaged, gas might escape from the tank.
WARNING
Physical access
Unauthorized personnel may potentially cause significant damage to and/or
misconfiguration of end users’ equipment. This could be intentional or
unintentional and needs to be protected against.
Physical security is an important part of any security program and
fundamental to protecting your system. Restrict physical access by
unauthorized personnel to protect end users’ assets. This is true for all
systems used within the facility.
CAUTION
Hot surfaces
The flange and process seal may be hot at high process temperatures. Allow
to cool before servicing.
Quick Start Guide September 2022
4 Emerson.com/Rosemount