User's Manual

4-3

Edition 1. Ref. No: 307010E

Transmitter Setup

4.1.3 Advanced Tank Geometry

Min. Level Offset C The C distance is used to extend the measurement

range beyond the Zero Level Reference Point down

to the tank bottom. C is defined as the distance

between the Zero Level and the tank bottom. Set

C=0 if you do not want to present negative levels

below the Zero Level reference point, or if you use

the tank bottom as zero level reference point.

Reference Distance G In most cases the LoopRadar Reference Point is

used as the upper reference point. However, the

LoopRadar gauge offers the option to use a nozzle

for hand dipping as the upper reference point.

G is the distance between the LoopRadar Refer-

ence Point and the Tank Ullage Reference Point.

The LoopRadar Reference Point is located at the

underside of the flange.

Tank height R The distance from the Tank Ullage Reference Point

to the Zero Level.

Level

LoopRadar Reference Point

Measuring Range

Product Surface

Ullage

Zero Level

Tank Ullage Reference Point