User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Tank Distances
6-3
Edition 2. Ref. No: 306010E
Lev 4.000 m
Ull 6.000 m
LRat 0.000 m/s
Sign 350 mV
Vol 0 m3
STATUS VALID
BACK
U=ullage
L=level
G=-0.5 m
R=10 m
“0”
U
L
0
4
10
Height (m)
Upper reference point
Lower reference point
Examples
The following examples illustrate how you can set the various
tank distance parameters to suit your own preferred reference
point settings.
Example 1
If you want set
Upper reference point at G=distance between
the tank roof flange and tank roof
(G<0).
Lower reference point at R=distance between upper
the bottom of the tank. reference point and the bottom
of the tank.
C=0.