User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Technical Information
7-3
Edition 2. Ref. No: 306010E
Display Panel
• For presentation of measured values and configuration of the
transmitter
• Graphical LCD display 128 x 64 pixels
• Four softkeys
• Text: 7 lines with 16 characters
• Graphics up to 128 X 56 pixels
• Supports service functions
Analog Outputs
Type Galvanically isolated, passive or active
output (external or internal loop supply)
Range 4-20 mA
Alarm level <3.6 mA or >21 mA software selectable
Resolution 0,5 µA (0.003%)
Output impedance > 10 MΩ
Loop resistance < 700 Ω with 24 V external supply
Voltage compliance 7-30 V