User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
ProMechanical Installation
2-14
Edition 2. Ref. No: 306010E
Flange
Guide pin
Antenna feeder
Hole
TRL2 adapter
Guide pin
Guide pin
Mounting the Parabolic Antenna
1. Mount the flange on top of
the antenna feeder. Use
the screws and nuts
delivered with the unit.
Make sure that the guide
pin at the bottom side of
the flange fits into the
corresponding hole on the
feeder. See illustration.
2. Mount the TRL2 adapter on top
of the flange and tighten the nuts
loosely in order to allow the
TRL2 adapter to be rotated.
The antenna feeder will be
aligned to the transmitter head
by using the two guide pins.
Note the positions of the guide
pins by for example putting a
mark at the holes in line with the
guide pins.