User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Electrical Installation
3-3
Edition 2. Ref. No: 306010E
5
4
3
2
1
X1 >
A
EExe
12345
+tuO
)yramirP(
-tuO
)yramirP(
rewoP
+/1L/L
rewoP
-/2L/N
toN
detcennoc
External Connections
Non-Intrinsically SafeJunction Box -EEx e
This Junction Box is for non-intrinsically safe connections and
power supply.
1-2 Non-intrinsically safe HART/4-20 mA primary analog output,
or
TRL/2 Bus
3-4 Power supply input
5 Not connected
A Electrical safety ground terminal
Note: redundant when the transmitter is grounded according to
CENELEC.
Cable shield
Connect the shield to the cable glands.