User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Electrical Installation
3-7
Edition 2. Ref. No: 306010E
X1
Junction Box
EEx e
1
2
3
4
5
100-240 VAC
or
24-48 VDC
123
456
78
9
250
Ω
V
s
X1
Junction Box
EEx e
1
2
3
4
5
100-240 VAC
or
24-48 VDC
123
456
78
9
Voltage compli-
ance 7-30 V
Input impedance
<300 Ohm
Connecting HART devices
Active output (internal loop supply)
Passive output (external loop supply)
A hand-held terminal or
a HART modem should
not be connected di-
rectly across an external
power supply. Instead,
it should be connected
across a load resistor of
about 250 Ω.
For Pro gauges with active
output a hand-held terminal or
a HART modem can be con-
nected as follows: