User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
3-14
Edition 2. Ref. No: 306010E
Saab TankRadar
®
ProElectrical Installation
X2
5
4
3
1
2
6
XA40
X6
X5
D
X7
IS Gnd
IS40
XA40
X6
B
DPS
DP+
SO-
SO+
PO+
PO-
X6
X2
5
4
3
1
2
XA40
X6
X5
C
IS40
XA40
X6
SO-
SO+
PO+
PO-
X6
A
Secondary Output
Intrinsic Safety (EEx i)
Option Description Board
A Non-intrinsically safe XA40+IS40
4-20mA active
C Non-intrinsically safe XA40
4-20mA passive
Note! This junction box is normally used for intrinsically safe connections. This
version is a non-intrinsically safe option equipped with an alternative
connector for non-intrinsically safe output.
Option Description Board
B Intrinsically Safe XA40+IS40
4-20mA active
D Intrinsically Safe XA40
4-20mA passive
Non-Intrinsic Safety (EEx e)