User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Pro Setup
4-11
Edition 2. Ref. No: 306010E
3 Select the Start Radar tab
1 Click the Read button.
Response: the current settings and the Start Code are displayed.
2 Check that the correct set of available options is displayed. Contact
your local representative if you like to add one or more of the follow-
ing software options: EchoFixer, MET, FHAST filtering or strap table
volume calculations.
3 Mark the check boxes that corresponds to available software op-
tions that you want to enable.
Note! The strapping table option can only be enabled by selecting the
Strapping Table option in the Volume tab.
4 Select the type of antenna to be used.
HP=high performance (Hastelloy, Tantalum, Titanium, Monel).
Std=standard.
P=PTFE tank sealing.
Q=Quartz tank sealing.
C=Ceramic.
Enter the pipe inner diameter if the antenna is mounted in a still
pipe.
The TCL parameter is entered for non-standard antennas only.