User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Pro Setup
4-13
Edition 2. Ref. No: 306010E
restricted to a region close to the tank
bottom (Related database register:
Full
tank detection area, 1516
).
Do not set this parameter if the bottom
echo is not visible.
Slow Search
This variable controls how to search for
the surface if a surface echo is lost. With
this parameter set the transmitter starts
searching for the surface at the last known
position, and gradually increases the width
of the search region until the surface is
found. If this varaible is not set the trans-
mitter searches through the whole tank.
This parameter may typically be used for
tanks with turbulent conditions.
6 Click the Store button if no further settings are required,
- or -
open the Tank Environment and Presentation Advanced tab to
make further settings:
For some parameters , e.g. Slow Search in the Tank Presentation
group, there is a related holding register which may need to be
changed in order to achieve the best measurement result. For these
parameters the related database registers appear in the bottom
pane of the Advanced tab.
You can edit the register value by simply putting the cursor in the
corresponding input field and enter the desired value.