User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Pro Setup
4-23
Edition 2. Ref. No: 306010E
2 Select a tank shape.
Select one of the tank shape options. Choose None if you don´t
want to use volume calculations. Use one of the ideal tank shape
options if approximation of your tank with an ideal tank shape
provides sufficient accuracy. The strapping table can be used for an
arbitrary tank shape. You can enter levels and corresponding vol-
umes to obtain a close match between the actual and the calculated
volume. This option should be used in cases where the tank shape
deviates significantly from an ideal sphere or cylinder, or when you
require high accuracy.
Note! The Strapping Table option can be used only if it is in the list of
available software options in the Start Radar tab.
6
Volume Calculations
Pro Setup performs Volume Calculations by using one of two
methods: predefined tank shape or strapping table. The strap-
ping table is an optional function. If it is not available a new
Start Code can be ordered from Saab Tank Control.
To enable Strapping Table select the corresponding option in the
Pro Setup/Volume window.
To configure the TR Pro Transmitter for volume calculations do
the following:
1 Select the Volume tab