User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
ProPro Setup
4-32
Edition 2. Ref. No: 306010E
To manually add items to the list of registered disturbing echoes
You can manually enter disturbing echoes which are not present in
the list of automatically detected echoes. This function can be
useful if there are objects below the product surface which can not
be detected by the gauge at the time of installation.
To manually add echoes do the following:
1 Enter an ullage value in the Location field. The entered value may
deviate up to 100 mm from the actual position of the object.
2 Click the Insert button.
Using the Set As Surface button
If the transmitter has locked on a disturbing object you can use the
Set As Surface function to point out the surface level. If there is an
echo that you recognize as the product surface rather than an
interfering echo, mark the echo and click the Set As Surface but-
ton.