User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
Pro Pro Display Panel
5-1
Edition 2. Ref. No: 306010E
MAIN MENU
View...
Service...
Setup...
NEXT
Operation
You can use the Display Panel (DP) for configuration as well as
for viewing tank data. The four softkeys allow you to navigate
through the different menus, and to select various functions for
service and configuration.
If you leave the DP in Service or Setup mode without pushing
any button for 10 minutes, the DP is automatically switched to
View mode, presenting the same measurement variable that was
displayed last time View mode was open.
The Main menu contains the following options:
5 Using the Pro Display Panel
• The View option allows you to view level data and signal
strength.
• The Service option allows you to view configuration status,
edit holding registers, reset holding registers to factory values,
do a software reset or to start a search for the surface echo.
• The Setup option allows you to configure a TankRadar Pro
transmitter.