User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
ProPro Display Panel
5-2
Edition 2. Ref. No: 306010E
Give password:
21
"231"
3
**
OK
Level
24.500
MENU ITEM GRPH
m
Adjusting the LCD contrast
The LCD contrast can be
increased by simultaneously
pressing the two buttons on
the right-hand side. Press
the two left-hand buttons to
decrease the contrast. It
takes approximately 10
seconds to adjust from
minimum to maximum display panel contrast.
Entering a Password
Some windows are protected
by a password. The password is
entered by pressing the three
blank softkeys in a certain
order (maximum 12 charac-
ters). Each figure refers to a
particular softkey, as illustrated
below.
As default the password is
blank, i.e. you can open a
password protected window
merely by pressing the
OK
button. In order to use the password protection you have to set
the password as described in Installing a Pro Transmitter/Display
Panel Setup.
If, for example, the password is “231”, you start by pressing the
second key, then the third key and finally the first softkey. You
can change password at any time by opening the Setup/Display
Panel menu.