User's Manual

28
Reference Manual
00809-0300-4248, Rev AA
Section 4: Commissioning
July 2014
Commissioning
4.4 Troubleshooting
If the device is not joined to the network after power up, verify the correct configuration of the
Network ID and Join Key, and verify that Active Advertising has been enabled on the Smart
Wireless Gateway. The Network ID and Join Key in the device must match the Network ID and
Join Key of the Gateway.
The Network ID and Join Key may be obtained from the Gateway on the Setup>Network>Set-
tings page on the web server (see Figure 4-1 on page 27). The Network ID and Join Key may be
changed in the wireless device by using the following Fast Key sequence.
4.5 Reference information
Figure 4-2. Rosemount 248 Wireless Terminal Diagram
Note
In order to communicate with a Field Communicator, the device must be powered by
connecting the Power Module.
Function Key sequence Menu items
Join Device to Network 2,1,1 Join to Network
Table 4-2. Rosemount WirelessHART 248 Fast Key Sequences
Function
Key
sequence
Menu items
Device Information 2, 2, 5, 3
Manufacturer, Model, Final Assembly Number, Universal, Field
Device, Software, Hardware, Descriptor, Message, Date, Model
Number I, Model Number II, Model Number III, SI Unit
Restriction, Country, Device ID
Guided Setup 2, 1
Join Device to Network, Configure Update Rate, Configure
Sensor, Calibrate Sensor
Manual Setup 2, 2
Wireless, Process Sensor, Percent of Range, Device
Temperatures, Device Information, Other
Wireless
Configuration
2, 2, 1
Network ID, Join Device to Network, Update Rate, Configure
Broadcast Power Level, Power Mode, Power Source
Sensor Calibration 3, 4, 1
Current Upper Trim, Current Lower Trim, Lower Sensor Trim,
Upper Sensor Trim, Recall Factory Trim, RTD 2 Wire Offset
Waiting for updated drawing.