User's Manual

RM5800 User Manual
Revision B.1 7
5.1.4 FCC Documentation Requirements
User documentation must contain the following statements:
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
• This device must be installed to ensure a minimum antenna separation distance of 20 cm from all
persons.
• Changes or modification to the equipment not expressly approved by Rosemount, Inc. could void
the user's authority to operate the equipment.
5.2 ISED COMPLIANCE TESTING
The RM5800 radio module has demonstrated compliance to ISED RSS 247. Host products are required to
meet all applicable requirements in RSS-Gen, including the radio frequency exposure compliance
requirements in RSS-102.
5.2.1 ISED Antenna Requirements
This radio module HVIN 5801 IC: 2731A-RM50801 has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna types:
1. Maximum 8.0dBi dipole antenna (tested kinds include Taoglas 2.5/3.0dBi PCB strip, Emerson
4.5dBi per drawing 00753-2035 and PCTEL 8.0dBi omnidirectional antenna BOA24008NF),
nominal impedance 50 ohms
2. Maximum 14.5dBi yagi-uda (tested L-COM 14.5dBi model HG2415Y-HF), impedance 50 ohms
3. Maximum 18dBi reflective array (tested L-COM 18dBi flat panel antenna model HG2418P),
impedance 50ohms
5.2.2 ISED Labeling Requirements
The exterior of the host product must have a label with the following (or similar) text specifying the IC
identifier in 4 points or larger.
Contains IC: 2731A-RM5801
5.2.3 ISED Documentation Requirements
User documentation of host products must contain the following statements:
• This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions: This device may not cause interference. This device must accept any
interference, including interference that may cause undesired operation of the device.
• Cet appareil est conforme à la norme RSS-247 Industrie Canada exempt de licence. Son
fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer