Installation guide

ManualsBrandsRosen ManualsDVD-playersAV7700 DVD ENTERTAINMENT SYSTEM

AV7700 System Installation Guide

AV7700 Installation Guide

Mercedes-Benz

NOTICE OF INTENDED INSTALLATION AND USE

ROSEN ENTERTAINMENT SYSTEMS VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING

BY THE DRIVER, AND ARE TO BE INSTALLED ONLY TO BE VIEWED BY REAR-SEAT

OCCUPANTS.

IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE

OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH,

AND COULD ALSO VIOLATE STATE LAW.

ROSEN ENTERTAINMENT SYSTEMS DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY

OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR UNINTENDED

INSTALLATION AND/OR USE.

STOP

Damage to the vehicle may occur

Do not proceed until process has been completed

CAUTION

Process must be carefully observed in order to reduce

the risk of damage to the accessory or vehicle

CRITICAL

Process must be carefully observed in order to ensure a

quality installation

TOOLS and EQUIPMENT

Specific tools and equipment recommended for this

process

SAFETY RISK

Observe safe practices, this process can be dangerous

and there is a risk of personal injury

TESTING and TROUBLESHOOTING

Content specific testing and troubleshooting points

AV7700 Mercedes-Benz Seat Back Headrest Solution

Summary of content (10 pages)

PAGE 1
AV7700 Mercedes-Benz Seat Back Headrest Solution AV7700 Installation Guide Mercedes-Benz NOTICE OF INTENDED INSTALLATION AND USE ROSEN ENTERTAINMENT SYSTEMS VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING BY THE DRIVER, AND ARE TO BE INSTALLED ONLY TO BE VIEWED BY REAR-SEAT OCCUPANTS. IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH, AND COULD ALSO VIOLATE STATE LAW.
PAGE 2
Installation Guide AV7700 PREPARING FOR THE INSTALLATION Before you start, please read these critical steps below STEP 1 BEFORE YOU START THE INSTALLATION, READ THIS GUIDE! VISIT Rosen Dealer Central For the latest Updates, Corrections and Technical Tips about this product and installation www.RosenDealerCentral.com CHECK THE BATTERY Test the battery voltage to make sure it’s fully charged to a minimum of 12.8 VDC This only takes seconds and can save hours of troubleshooting later.
PAGE 3
Installation Guide AV7700 Prepare Electronics You will need to install the vehicle specific mounting brackets. The following steps will guide you through this process Note: Mercedes-Benz GL/ML/R installation shown STEP 2 Locate hardware mounting kit. (Part# MB100B contents shown) Locate clean, non-abrasive working surface to prepare the headrest units. Determine the proper mounting bracket positions according to your vehicle application.
PAGE 4
Installation Guide AV7700 Routing Cable Through Headrest Bracket You will need to route the cable through the headrest bracket. The following steps will guide you through this process Note: Mercedes-Benz GL/ML/R installation shown STEP 3 Place the AV7700 electronics system on clean flat surface. Route cables through rectangular slots in mounting brackets.
PAGE 5
Installation Guide AV7700 Installing AV7700 Electronics You will need to install the AV7700 electronics and route the cable through the seat backs. The following steps will guide you through this process. STEP 5 Note: Mercedes-Benz GL/ML/R installation shown Route cables into seat along post guides. Cables are Left/Right specific based on mounting orientation of electronics (Both cables will be black with connection points being color specific. IE: Black & Grey) CAUTION Locate mounting bushings.
PAGE 6
Installation Guide AV7700 Steps For Mounting Electronics Into Bushings Below are steps to lock mounting brackets into bushings Note: Mercedes-Benz GL/ML/R installation shown STEP 6 Step A Slide mounting brackets into bushings Step B Locate locking pin Step C Insert locking pin by sliding through both locking positions on bracket Note: Moderate force may be needed to engage locking pin Step D Locking pin fully inserted Image of both locking pins and electronics fully installed Rosen Entertainment Syst
PAGE 7
Installation Guide AV7700 Routing Harnesses and Making Connections You will need to route the harnesses and make the power connections to the vehicle. Proper routing of cables is crucial to making sure cables do not get damaged STEP 7 This system requires a minimum of 12V (+) ACC Switched and Ground (-) to operate. The 12V (+) ACC Switched source must be capable of supplying a minimum of 7A.
PAGE 8
Installation Guide AV7700 Initial Test, Reassembly, and Pre-delivery Re-test You will need to fully test the system to ensure it is working and connected to the vehicle properly. The following steps will guide you through this process STEP 9 Step 1: INITIAL TEST (Do this BEFORE you reassemble any trim panels) a. Reconnect the vehicle battery if needed b. Install batteries into the remote control, headphones and game controllers c.
PAGE 9
Installation Guide AV7700 Installer Settings The steps below will show you how to access the installer settings menu this process STEP 10 To access install setup menu: use the remote control, press “EJECT-ENTER-1-1-2-0” • • • • To change AUX 2 input labeling, highlight AUX 2 label and scroll left/right using arrows. To select EXT FMM, highlight EXT FMM and select on. POD ADDR is used to manually set pod address AutoÆ address is based on which port the pod is plugged into.
PAGE 10
Installation Guide AV7700 Service and Optional Parts List Part Number AP1003 AP1008 AP1010 AP1007 AC3640 AP2003 AP1029 AP2020 AP1021 Description Interface Module Harness, Power Harness, Interface Control, Game System Headphones, 2 CH.