User manual Refrigerator RJKL3741X
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 4 6 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 E
squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. • This appliance is heavy. Care should be taken when moving it.
Control panel The Pilot light will switch off. Temperature regulation The temperature is automatically regulated. To operate the appliance, proceed as follows: • turn the Temperature regulator counter clockwise to obtain warmer storage temperature. • turn the Temperature regulator clockwise to obtain colder storage temperature. A medium setting is generally the most suitable. 1 Pilot light 2 Temperature regulator Switching on Insert the plug into the wall socket.
The space directly above the glass shelf of the fruit and vegetable drawer is the coldest region of the refrigerator compartment as shown in the figure. For proper storage of the food in your refrigerator and particularly in the coldest area, ensure that the temperature indicator is displaying “OK”. If “OK” is not displayed, the average temperature in the area is too high. Adjust the temperature controller to a colder setting.
Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
Important! Take care of not to damage the cooling system. Important! When moving the cabinet, lift it by the front edge to avoid scratching the floor. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason use a soft cloth rinsed in warm water and neutral soap emulsion for cleaning external surfaces. Important! Do not use detergents or abrasive paste as these will damage the paint, or stainless steel anti finger print coating.
Problem The appliance is noisy. Possible cause Solution The appliance is not supported prop- Check if the appliance stands stable erly. (all feet and wheels should be on the floor). Refer to "Levelling". The cushion spacers located bePut them back in place again. tween the back of the cabinet and the pipes come loose. The compressor runs contin- The Temperature regulator may be set incorrectly. uously. Set a warmer temperature. The door is not closed correctly. Refer to "Closing the door".
Problem Possible cause Solution Large quantities of food to be cooled Insert smaller quantities of food to be were put in at the same time. cooled at the same time. The appliance does not oper- The appliance is switched off. ate. The mains plug is not connected to the mains socket correctly. Switch on the appliance. Connect the mains plug to the mains socket correctly. The appliance has no power. There Connect a another electrical appliis no voltage in the mains socket. ance to the mains socket.
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Electrical connection SN +10°C to + 32°C N +16°C to + 32°C Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed.
To remove them proceed as follows: 1. Move the shelf holders in the direction of the arrow (A). 2. Raise the shelf from the rear and push it forward until it is freed (B). 3. Remove the retainers (C). Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied. Door alignment is dependent on proper levelling. Door reversibility To change the opening direction of the door, do these steps: • Remove the plug from the power.
Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent 12 potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
www.electrolux.
