User manual Refrigerator RJKL3850 RJKL3850X
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 4 5 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _
Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. 2. • • • • Power cord must not be lengthened. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
Control panel MAX To operate the appliance, proceed as follows: • turn the Temperature regulator counter clockwise to obtain warmer storage temperature. • turn the Temperature regulator clockwise to obtain colder storage temperature. min 1 2 1 Fridge temperature regulator 2 Fridge OFF position Switching on Insert the plug into the wall socket. Turn the Fridge Temperature regulator clockwise to a medium setting.
Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Important! Do not move the big lower door shelf to ensure correct air circulation. Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. Important! Do not pull, move or damage any pipes and/or cables inside the cabinet.
What to do if… During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. Important! The appliance operates discontinuously, so the stopping of compressor does not mean being no current. That is why you must not touch the electrical parts of the appliance before breaking the circuit.
Problem Possible cause Solution The door is not closed correctly. Refer to "Closing the door". The food temperature is too warm. Let the food temperature decrease to room temperature before storage. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. Large quantities of food to be cooled were put in at the same time. Insert smaller quantities of food to be cooled at the same time. The appliance is switched off.
Technical data RJKL3850 RJKL3850X Dimension Height 1850 mm 1850 mm Width 595 mm 595 mm Depth 623 mm 623 mm Voltage 230 V 230 V Frequency 50 Hz 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
1. 2. 3. Open the door. Remove the transport support from the door sides. Remove the transport support from the lower hinge (some models). a3 3 2 Important! Some models are fitted with a silencing pad under the cabinet. Do not remove this pad. Spacers Install the spacers provided within the accessory bag as shown in the figures. Place the spacers on the brackets of the condenser (the black grill) at the back of the appliance. a1 • Unscrew the lower hinge (a1).
Warning! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. Do a final check to make sure that: • All screws are tightened. • The edges of the doors run parallel to the side edge of the appliance. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. Warning! If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket.
www.electrolux.
