User manual

Important! Never use sharp metal tools to scrape off
frost from the evaporator as you could damage it. Do
not use a mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. A temperature rise
of the frozen food packs, during defrosting, may shorten
their safe storage life.
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:
1. disconnect the appliance from electricity supply
2. remove all food
3. defrost and clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant
smells.
Important! If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the food inside
from spoiling in case of a power failure.
What to do if…
During operation of the appliance some smaller but an-
noying trouble can often occur, which does not require
calling a technician out. In the following chart informa-
tion is given about them to avoid unnecessary charges
on service.
Important! The operation of the appliance goes with
certain sounds (compressor and circulating sound). This
not means a trouble, but a normal operation.
Important! The appliance operates discontinuously, so
the stopping of compressor does not mean being no
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
Problem Possible cause Solution
The appliance is noisy. The appliance is not supported prop-
erly.
Check if the appliance stands stable
(all feet and wheels should be on the
floor). Refer to "Levelling".
The compressor runs contin-
uously.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer than
necessary.
The food temperature is too varm. Let the food temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
There is too much frost and
ice.
The door is not closed correctly. Refer to "Closing the door".
The door gasket is deformed or dirty. Refer to “Closing the door”.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
The temperature in the appli-
ance is too cold.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
The temperature in the appli-
ance is too warm.
The Temperature regulator may be
set incorrectly.
Set a colder temperature.
7