BRONZE POWER SUPPLY User’s Manual HIVE-550 HIVE-650 HIVE-750
Contents Features P. 2 Input & Ouput Rating P. 2 Package Content P. 3 Connector P. 4 Caution P. 4 Installation P. 5 Easy Trouble Shooting P. 6 Information P.
Features • ATX12V v2.31 & EPS12V v2.92 • 80PLUS BRONZE Certified • Full Range Active-PFC • Eup Ready • Multi-GPU Support - 2/4 x PCI-E 6+2-pin Connector • Silent 135mm Fan with Auto Speed Control • Modular Cable Design • High Quality Japanese Primary Capacitor • Over Current/Voltage/Temperature/Power Protection, Under Voltage Protection and Short Circuit Protection • 3-Year Warranty - One to One Replacement Input & Output Rating HIVE-550 DC OUTPUT +3.3V +5V MAX.
Package Content HIVE-550 • Power Supply • User Manual • AC Power Cord • Cable Ties • Mounting Screws • Bag for Modular Cables • Modular Cable Set 2x PCI-E 6+2-pin cable 2x Four SATA cable 2x Two Molex + One Floppy cable HIVE-650 • Power Supply • User Manual • AC Power Cord • Cable Ties • Mounting Screws • Bag for Modular Cables • Modular Cable Set 2x PCI-E 6+2-pin cable 2x Four SATA cable 2x Two Molex + One Floppy cable HIVE-750 • Power Supply • User Manual • AC Power Cord • Cable Ties • Mounting Screws
Connector HIVE-550 HIVE-650 HIVE-750 ATX 20+4 pin 1 1 1 ATX/EPS12V 4/8 pin 1 1 1 EPS12V 8 pin 1 PCI-E 6+2 pin 2 2 4 SATA 8 8 8 Molex 4 pin 4 4 6 Floppy 2 2 2 Caution • Please do not store the power supply in a high humid temperature place, or to be used in such condition. • High voltages exist in the power supply. Unless authorized personnel, please do not open the PSU cover. The warranty will be void if the cover is removed.
Installation • Please make sure the power supply is not connected to the AC power cord. • Make sure the I/O switch of the PSU is at off “O” position. • Install the power supply into the chassis. (refer to your chassis manual) • Please refer to your motherboard user manual to confirm 20-pin or 24-pin main connector it needs. If 24-pin, you can plug the 24-pin main connector onto the motherboard. If 20-pin, please detach the 4-pin to have a 20-pin main connector then plug it onto the motherboard.
Easy Trouble shooting If your PC system does not respond, please make following checks: 1. make sure the AC power cord is connected firmly and the AC power switch is turned on. 2. Make sure all DC output connectors are connected in the right direction and plugged firmly. 3. Check whether there is any short circuit problem or defective peripherals by unplugging each peripheral device one at a time. 4.
BRONZE www.rosewill.
