User's Manual

Wireless 11ac Dual Band USB Adapter AC1200UBE User Manual
49
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The exposure standard for wireless device employs a unit of measurement known as the Specific Absorption Rate, or
SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating
can be well below the maximum value. This is because the device is designed to operate at multiple power levels so
as to use only the poser required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
SAR compliance has been established in the host product(s) (laptop computers), tested at 5mm separation distance to
the human body, and tested with USB slot configurations including Horizontal-UP, Horizontal-Down, Vertical-Front,
Vertical-Back. This device can be used in host product(s) with substantially similar physical dimensions, construction,
and electrical and RF characteristics.
The highest SAR value, tested per FCC RF exposure guidelines for USB dongle, as described in this user guide, is
1.19 W/kg. The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as
in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be
found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: W6R-AC1200UBE.
This USB dongle transmitter is approved for use in typical laptop computers. To comply with FCC RF exposure
requirements, this USB dongle should not be used in other devices or certain laptop and tablet computer
configurations where the USB connectors on the host computer are unable to provide or ensure the necessary
operating configurations intended for the device and its users or bystanders to satisfy RF exposure compliance
requirements. This USB dongle should be installed and operated with minimum distance 5mm between the radiator &
your body.
Your product is marked with this symbol, which is known as the WEEE mark. WEEE stands for Waste
Electronics and Electrical Equipment. It means that used electrical and electronic products should not
be mixed with general waste. Used electrical and electronic equipment should be treated separately.