Service manual

R910E Service Manual

3. OPERATING INSTRUCTIONS

3.1 GENERAL INSTRUCTIONS

Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the

monitor. By changing these settings, the picture can be adjusted to your personal preferences.

The power cord should be connected.

Connect the video cable from the monitor to the video card.

Press the power button to turn on the monitor, the power indicator will light up.

3.2 CONTROL BUTTONS

3.2.1 KEY CONTROL

3.2.2 KEY FUNCTION

• ⑥Power Button:

Press this button to switch the monitor’s power ON or OFF.

• ④MENU / ENTER:

Activate OSD menu when OSD is OFF or activate/de-activate adjustment function when OSD is ON or Exit OSD menu when

in Brightness/ Contrast OSD status.

• ②Brightness / :

Adjust brightness or function adjust.

• ⑦Headphone Jack

• ③Contrast / :

Adjust contrast or function adjust.

• ①Auto Adjust button / Exit:

1. When OSD menu is in active status, this button will act as EXIT-KEY

(EXIT OSD menu)

2. When OSD menu is in OFF, press this button for 2 seconds to activate the Auto Adjustment function.

The Auto Adjustment function is used to set the HPos, VPos, Clock and Focus.

• ⑤Power Indicator:

Green — Power On mode.

Orange — Off mode.