2 ports Parallel PCI card RC304 User Manual
ports Parallel PCI card RC304 User Manual Overview This PCI card is a dual 1284 parallel port controller with PCI bus interface and supports the existing contronics printer interface as well as PS2, EPP & ECP modes and uses an all-in-one solution from NeMos Technology, which provides superior performance and unmatched data transfer rates. The most advanced feature is it uses of a single interrupt, which is set automatically by the host system and share among all on-board I/O ports.
2 ports Parallel PCI card RC304 User Manual Driver Installation Windows 95/98/2000 Once the PCI I/O card is installed and the computer is restarted, Windows will detect the board and attempt to install driver for it. 1. Start Windows 95/98/2000 2. The“Update Device driver Wizard” will appear, informing you that it has found a “PCI I/O Card”. Click the “Next” button. 3. Click “Other Location” for Windows 95 or “Specify a location” for Windows 98 to install the driver.
2 ports Parallel PCI card RC304 4. User Manual Insert the driver CD in CD-ROM drive(D) and click on the “Browse” button. 5. at the “Browse” option, select “CD-ROM(D) FOLDER “OK” button 6. 7. . 8. “PCI_I/O\NM97X5\WIN9X” The “Update Device Driver Wizard” will appear, informing you that it has found the “NetMos PCI I/O Card” driver. Click the “Next” button. Follow the instructions to finish up the drive installation.
2 ports Parallel PCI card RC304 User Manual Windows NT 4.0 Using the existing hard disk controller in your system, you need to install the ATA/100 driver into Windows NT first. Without ATA/100 driver support, hard drive attached to the ATA/100 IDE controller card can not boot up Windows NT. Installing drivers with existing Windows NT 4.0: Make sure Windows NT 4.0 is properly installed into your system first. Step 1: Start Windows NT 4.0. Step 2: Insert Driver CD into the CD-ROM drive.
