Gigabit PCI LAN Card RC400-LX User Manual
Gigabit PCI Card RC400-LX User Manual Features and Benefits z Integrated 10/100/1000 transceiver z Supports PCI 2.2, 32 bit bus, 33/66MHz z Fully compliant with IEEE 802.3 (10Base-T Ethernet), IEEE 802.3u (100Base-TX Fast Ethernet), IEEE 802.
Gigabit PCI Card RC400-LX User Manual Hardware Installation Follow the instruction given below to install the Gigabit Ethernet PCI Card. 1. Turn your computer off and remove the power plug from the plug socket. 2. Remove the cover from the computer case. 3. Remove the metal cover plate on the rear of a free PCI slot. 4. Insert the card into one free PCI slot and screw it firmly on the bracket side. 5. Place the cover back onto the computer. 6. Insert the plug into plug socket.
Gigabit PCI Card RC400-LX User Manual For Windows® Vista In Windows® Vista, when the system is booted up it automatically detects the Gigabit Ethernet PCI Card and install the Gigabit Ethernet PCI Card with in-build drivers. Following is the procedures for upgrading Gigabit Ethernet PCI Card driver under Windows® Vista operating system. 1. Please insert the CD driver bound with Gigabit Ethernet PCI Card into your CD-ROM Drive. 2. At the Windows desktop click Start, then Run. 3. Type D:\ RC400-LX \setup.
Gigabit PCI Card RC400-LX User Manual Networking Settings 1. Click “Network Connection” in Control Panel to set your network settings. 2. Right-click the Local Area Connection used by the Gigabit Ethernet PCI Card, then select “Properties” from the pop-up menu. 3. Double-click the “Internet Protocol (TCP/IP)” item to set network settings. 4. Right-click the Local Area Connection used by the Gigabit Ethernet PCI Card, then select “Status” from the pop-up menu. You can affirm network status.
Gigabit PCI Card RC400-LX User Manual this card has not been inserted into the PCI slot correctly. Please insert the card firmly into the PCI slot or try another slot. How to deal with an exclamation point on Ethernet Host controller 1. Please shutdown your computer and move the card to another available slot then re-install Gigabit Ethernet PCI Card driver again. 2. Please point on this device then right-check on the mouse. 3.
