SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual This Manual for the Models of 2 Channels SATA HBA: Model A: Low Profile Serial ATA Internal 2 Ports Model B: Low Profile External 1 Port + Internal 1 Port Model C: Low Profile Internal 1 Port + External 1 Port + Bracket Power Model D: External 2 Ports + Bracket Power 1. Introduction The Low Profile Serial ATA 2 Channels PCI Host Adapter is a PCI to dual Serial ATA host controller board which can support Low profile PCI and regular size PCI both.
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual 1st generation Serial ATA data rates. (1.5Gb/s) • Fully compliant with Serial ATA 1.0 specifications. • Supports Spread Spectrum in receiver. • Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes. 1.1.3. The Individual features for different Models 1.1.3.1. Model A: Serial ATA Internal 2 Ports • Supports Independent two Internal Ports. 1.1.3.2.
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual PCI Host Adapter for the operating systems: New & Existing Windows 98/98 SE New & Existing Windows ME New & Existing Windows NT 4.0 New & Existing Windows 2000 New & Existing Windows XP 2.1. Windows 98/98SE Driver Installation For New Windows 98/98 SE Systems 1. After the Serial ATA PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly. 2.
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual Manager tab. 3. Double click Other Devices then PCI RAID Controller. 4. Click Driver tab, then Update Driver. 5. Insert the Driver diskette, check Specify the location of the driver (advanced) and click Next. 6. Select Search for the better driver option, check Specify a location, uncheck Removable Media, type in A:\, and click Next. 7. Click Next and then Finish. 8.
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual Double click My Computer/Control Panel/SCSI Adapters, then click the Drivers tab. 2. Click Add… then Have Disk.... 3. Insert the Driver diskette into the floppy drive and type in A:\, then click OK. 4. Highlight Silicon Image Sil-3112 Serial ATA Controller and click OK. 5. Remove the Driver diskette and restart Windows. Verification of the Proper Installation for Windows NT 4.0 1. Double click My Computer/Control Panel/SCSI Adapters. 2.
SATA-150 1-Int/1-Ext Port PCI Adapter RC205 User Manual Installation warning pops up, click Yes again. For Existing Windows XP (in old ATA channel) Systems 1. After the Serial ATA PCI Host Adapter and attached drives are configured, boot up Windows. 2. At the Found New Hardware Wizard, check Install from a list or specific location (advanced), then click Next. 3. Insert the Driver diskette. Check Include this location in the search, uncheck the other box, type in A:\, and click Next. 4.
