RCX-Z1 User Manual
RCX-Z1 Installation Instruction Installation Instruction Warning Improper installation will result in damage to the processor. Never switch on the computer system until the fan is connected on to the motherboard power connector. SPECIFICATION Fan Size 92mm Compatibility AMD Socket 754, 939, 940 & AM2 Bearing Type : Ball bearing for over 45000/hrs RPM 1700 - 3100 R.P.M. Air Flow 33 – 57.2 CFM; 1.14 - 3.34mm H20 control by fan controller bracket Noise Level 18 - 33.
RCX-Z1 Installation Instruction Step TWO Clip Attachment 1. Place heatsink inside retention module on the CPU . 2. Carefully engage each clip with retention module. 3. Gently squeeze the clip down so that latch tightly with retention module. Step THREE 1. Remove a PC I slot backplate and install the fan control unit. 2.
RCX-Z1 Installation Instruction 3. Connect the 3-pin connector of the fan cable assigned with a yellow and a black cable to the CPU fan motherboard connector. Step FOUR Connect the 3-pin connector with the yellow/red/ black cable to the Controller Circuit board Thank you for purchasing a quality Rosewill Product. Please register your product at : www.rosewill.com/ for complete warranty information and future support for your product.
