The RFS-105 / RFS-108 is a high-performance Fast Ethernet switch, with all ports capable of 10 or 100Mbps auto-negotiation operation. Store-and-forward switching mode promises the low latency plus eliminates all the network errors, including runt and CRC error packets. To work under full-duplex mode, transmission and reception of the frames can occur simultaneously without causing collisions as well as double the network bandwidth.
RFS-108 Features: 8 x 10/100Mbps RJ-45 Nway ports Supports 802.3az Green Ethernet: Detecting port usage power saving and cable length power saving Supports NWay protocol for speed (10/100Mbps) and duplex mode (Half/Full) auto-detection Supports MDI/MDI-X auto crossover Supports full and half duplex operation on all ports Supports back-pressure (half duplex) and flow control (IEEE 802.3x) Supports 802.
Please refer to the following table for LED definition 5port 8port LED Power Status Steady Green Off Link/Act Steady Green Blinking Green Off Operation Power is on Power is off The port is connected The port is transmitting/receiving data. No connection Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready.
In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to make a switch-to-switch connection is allowed. For cable selection, refer to the following table： Network Speed Cable Type Max. Length 10Mbps Cat. 3, 4, 5 UTP/STP 100 meters 100Mbps Cat.
RFS-105 Spec Switch Type Desktop Standards 802.3 Ethernet, 802.3u Fast Ethernet, 802.3x Full-Duplex Flow Control, 802.3az Energy Efficient Ethernet Network Management Type Unmanaged Ports 5 x RJ45 Speed 10/100Mbps MAC Address Table 1K Buffer Memory 384K bits (48KB) Switching Method Store and Forward LEDs System: Power Port: Link/Act Power External Power 5V0.6A Dimensions 4.76" x 2.95" x 1.02" (121 x 75 x 26 mm) Weight 0.57 lbs. (258.
RFS-108 Spec Switch Type Desktop Standards 802.3 Ethernet, 802.3u Fast Ethernet, 802.3x Full-Duplex Flow Control, 802.3az Energy Efficient Ethernet, 802.1p QoS data management Network Management Type Unmanaged Ports 8 x RJ45 Speed 10/100Mbps MAC Address Table 1K Buffer Memory 768K bits (96KB) Switching Method Store and Forward LEDs System: Power Port: Link/Act Power External Power 5V0.6A Dimensions 6.08" x 2.95" x 1.02" (155 x 75 x 26 mm) Weight 0.76 lbs.
FCC Certifications This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
