6 Ports Gigabit Switch RGS-1016 User Manual
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of Rosewill Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from Rosewill Inc. Copyright © 2010 Rosewill Inc. All rights reserved. http://www.rosewill.
CE Mark Warning This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Safety Warning Place connecting cables carefully so that no one will step on them or stumble over them. Always disconnect all cables from this device before servicing or disassembling. Use ONLY an appropriate power adaptor or cord for your device.
Package Contents The following contents should be found in your package: One RGS-1016 Switch One power cord This User Guide Rubber footpads Rack-mount kit for installing the switch in a 19-inch rack Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact with your distributor.
Key Features Supports IEEE 802.3az Energy Efficient Ethernet 16 port auto-sensing 10/100/1000 Mbps Ethernet connections Bandwidth: 32 Gbps (non-blocking) Supports NWay protocol for speed(10/100/1000Mbps) and duplex mode(Half/Full) auto-detection Supports MDI/MDI-X auto crossover and polarity correction Store-and-forward architecture filters fragment & CRC error packets Supports 802.
Front Panel The front panel consists of LED indicators and the ports. 16 Port 19-inch Model Gigabit Ethernet Ports: The switch includes 16 gigabit twisted pair ports, each supporting auto negotiable 10/100/1000 Mbps and auto MDI/MDIX cross over detection functions. This function provides true “plug and play” capability. These ports can operate in half-duplex mode for 10/100 Mbps.
Installation This switch can be mount in the rack or mount on the wall. You can choose the suitable one to install your device. Before installing the switch, we strongly recommend: The switch is placed with appropriate ventilation environment. A minimum 25mm space around the unit is recommended. 1. 2. The switch and the relevant components are away from sources of electrical noise such as radios, transmitters and broadband amplifiers. The switch is away from environments beyond recommend moisture.
6. 7. Insert the unit into the rack with suitable screws Reconnect all the cables. Network Cables In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to make a switch-to-switch connection is allowed. 1. Crossover or straight-through cable: All the ports on the switch support Auto-MDI/MDI-X functionality.
Cable Connections Network Data Rate RJ-45 (10BASE-T): Category 3,4,5 UTP/STP RJ-45 (100BASE-TX): Category 5 UTP/STP RJ-45 (1000BASE-T): Category 5e, 6 or enhanced UTP/STP 10/100/1000 Mbps Auto-negotiation 10/100Mbps: Full-duplex, Half-duplex 1000Mbps: Full-duplex System: Power LED Indications Ports: Link/ACT MAC Address Table 8K Buffer Memory 256K bytes Jumbo Frame 9K bytes QoS 802.
