User Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the router
- 4.1 Login
- 4.2 Status
- 4.3 Quick Setup
- 4.4 Operation Mode
- 4.5 WPS
- 4.6 Network
- 4.7 Wireless
- 4.8 DHCP
- 4.9 NAT
- 4.10 Forwarding
- 4.11 Security
- 4.12 Parental Control
- 4.13 Access Control
- 4.14 Advanced Routing
- 4.15 Bandwidth Control
- 4.16 IP& MAC Binding
- 4.17 Dynamic DNS
- 4.18 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Wireless Router RNX-N150RT User Manual
Figure 3-15 WAN Connection Type
The router supports three popular ways Dynamic IP, PPPoE and Static IP to connect to the
Internet. Please select the very type and click Next to continue configuring.
2. Make sure the cable is securely plugged into the WAN port before detection. The appropriate
configuration page will be displayed when an active Internet service is successfully detected
by the router.
1) If the connection type is Dynamic IP, the next screen will appear as shown in Figure 3-16.
MAC Clone is necessary for most user
s using Cable Modem. It's highly recommended to
do this on the MAIN COMPUTER that was originally connected to your Cable Modem.
Figure 3-16 MAC Clone
2) If the connection type is PPPoE, the next screen will appear as shown in Figure 3-17.
Figure 3-17 Quick Setup - PPPoE
- 17 -