User Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the router
- 4.1 Login
- 4.2 Status
- 4.3 Quick Setup
- 4.4 Operation Mode
- 4.5 WPS
- 4.6 Network
- 4.7 Wireless
- 4.8 DHCP
- 4.9 NAT
- 4.10 Forwarding
- 4.11 Security
- 4.12 Parental Control
- 4.13 Access Control
- 4.14 Advanced Routing
- 4.15 Bandwidth Control
- 4.16 IP& MAC Binding
- 4.17 Dynamic DNS
- 4.18 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Wireless Router RNX-N150RT User Manual
Wireless Name of Remote AP - The SSID of the AP your router is going to connect to as a
client. You can also use the search function to select the SSID to join.
MAC Address of Remote AP - The BSSID of the AP your router is going to connect to as a
client. You can also use the search function to select the BSSID to join.
Survey - Click this button, you can survey the AP which runs in the current channel.
Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the router can be used. It may be illegal to use the wireless function of
the router in a region other than one of those specified in this field. If your country or region is
not listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, click the Save button, then the
Note Dialog appears. Click OK.
Note Dialog
Note:
Limited by local law regulations, version for North America does not have region selection option.
Wireless Security Mode - You can select one of the following security options:
Most Secure (WPA/WPA2-PSK) - Select WPA based on pre-shared passphrase.
Secure (WEP)- Select WEP based on none pre-shared passphrase.
No Security - The wireless security function is disabled. The wireless stations will
be able to connect the Device without encryption.
Wireless Password - Enter an 8 to 63 character alphanumeric pass-phrase. For good
security it should be of enough length and should not be a commonly known phrase.
These settings are only for basic wireless parameters. For advanced settings, please refer to
Section 4.7 Wireless.
Click Survey button on the Wireless page as shown in Figure 3-22, and then AP List page will
appe
ar as shown in Figure 3-23. Find the SSID of the Access Point you wan
t to access, and click
Connect in the corresponding row. For example, the first item is selected. The target network’s
SSID will be automatically filled into the corresponding box which is shown as the Figure 3-24.
- 21 -