User Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the router
- 4.1 Login
- 4.2 Status
- 4.3 Quick Setup
- 4.4 Operation Mode
- 4.5 WPS
- 4.6 Network
- 4.7 Wireless
- 4.8 DHCP
- 4.9 NAT
- 4.10 Forwarding
- 4.11 Security
- 4.12 Parental Control
- 4.13 Access Control
- 4.14 Advanced Routing
- 4.15 Bandwidth Control
- 4.16 IP& MAC Binding
- 4.17 Dynamic DNS
- 4.18 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Wireless Router RNX-N150RT User Manual
DHCP Server - Enable or Disable the server. If you disable the Server, you must have
another DHCP server within your network or else you must configure the IP address of the
computer manually.
IP Address - Enter the IP address of your system in dotted-decimal notation (factory default:
192.168.1.1).
Subnet Mask - An address code that determines the size of the network. Normally
255.255.255.0 is used as the subnet mask.
Note:
If you change the IP address, you must use the new IP address to login the system.
Change the login account - if you select the YES radio, you can modify your login user
name and password.
Note:
The new user name and password must not exceed 14 characters in length and must not
include any spaces. Enter the new Password twice to confirm it.
5. Click the Next button. You will then see the page as shown in Figure 3-37. Please click the
Reboot/Finish button to make your configuratio
n take effect and finish the Quick Setup.
Figure 3-37 Quick Setup – Finish
Note:
You may click the Save button to save these settings as a text file for future reference.
- 30 -