User Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the router
- 4.1 Login
- 4.2 Status
- 4.3 Quick Setup
- 4.4 Operation Mode
- 4.5 WPS
- 4.6 Network
- 4.7 Wireless
- 4.8 DHCP
- 4.9 NAT
- 4.10 Forwarding
- 4.11 Security
- 4.12 Parental Control
- 4.13 Access Control
- 4.14 Advanced Routing
- 4.15 Bandwidth Control
- 4.16 IP& MAC Binding
- 4.17 Dynamic DNS
- 4.18 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Wireless Router RNX-N150RT User Manual
Figure 4-4 WPS
WPS Status - Enable or disable the WPS function here.
Current PIN - The current value of the router's PIN is displayed here. The default PIN of the
router can be found in the label or User Guide.
Restore PIN - Restore the PIN of the router to its default.
Gen New PIN - Click this button, and then you can get a new random value for the router's
PIN. You can ensure the network security by generating a new PIN.
Add device - You can add a new device to the existing network manually by clicking this
button.
b) To add a new device:
If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless
connection between wireless adapter and router using either Push Button Configuration (PBC)
method or PIN method.
Note:
To build a successful connection by WPS, you should also do the corresponding configuration of
the new device for WPS function meanwhile.
I. Use the Wi-Fi Protected Setup Button
Use this method if your client device has a Wi-Fi Protected Setup button.
Step 1: Press the WPS/Reset button on the front panel of the router for one second.
You can also keep the default Status as Enabled and click the Add Device button in
Figure 4-4, then Choose “Press the button of the
new device in two minutes” and click
Connect. (Shown in the following figure)
- 34 -