User's Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Installation
- Chapter 3 Connect to a Wireless Network
- Chapter 4 Configuration Using Wireless N Client Utility
- Chapter 5 AP Mode (Windows 7 Only)
- Appendix A: Specifications
- Appendix B: Glossary
- Appendix C: FAQ
Wireless N PCI Adapter RNX-N250PC2 User Manual
21
3.2 To connect using WPS
WPS (Wi-Fi Protected Setup) function allows you to add a new wireless device to an existing
network quickly.
If the wireless router supports Wi-Fi Protected Setup (WPS) or QSS, you can establish a wireless
connection between wireless card and router using either Push Button Configuration (PBC)
method or PIN method. Three WPS connection methods are listed in the following parts while the
third method is only supported in Windows XP and Windows Vista.
3.2.1 PBC (Push Button Configuration) method
1. Press the WPS/QSS button on the back panel of the router.
2. Open Wireless N Client Utilityand click WPS tab. Select Push the button on my access
point or wireless router and then click Connect.
Figure 3-7
3. The adapter will be connecting to the target network.
Figure 3-8
4. When the following window appears, you have successfully connected to the network.