User's Manual
Table Of Contents
- Package Contents
- Chapter 1 Product Overview
- Chapter 2 Installation
- Chapter 3 Connect to a Wireless Network
- Chapter 4 Management
- Chapter 5 SoftAP Mode
- Chapter 6 Uninstall Software
- Appendix A: Specifications
- Appendix B: Glossary
RNX-N300UB
300Mbps Wireless N USB Adapter
4
Chapter 2 Installation
2.1 Hardware Installation
Plug the adapter into an available USB interface on your computer directly.
Note:
The prompted Found New Hardware Wizard screen will pop up when the adapter is installed
correctly. Click Cancel.
2.2 Software Installation
The adapter’s Setup Wizard will guide you through the installation procedures for Windows 7,
Windows 8, Windows 8.1, Windows Vista, and Windows XP. The procedures in different
systems are quite similar, therefore here takes the procedures in Windows 7 for example.
1. Insert the Resource CD into your CD-ROM drive and then go to My Computer.
Double-click CD-ROM RNX-N300UB, and you will see the window as shown in Figure 2-1.
Double-click Setup.exe to start the installation.
Figure 2-1