User manual

Wireless Adapter RNX-N4 User Manual
9
2. UNDERSTANDING THE HARDWARE
2.1 HARDWARE INSTALLATION
• Place the unit in an appropriate location after conducting a site survey.
• Plug one end of the Ethernet cable into the LAN port of the device and another end into your
PC/Notebook.
• Plug one end of another Ethernet cable to WAN port of the device and the other end into
you cable/DSL modem (Internet)
• Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the other end into
the power socket on the wall.
This diagram depicts the hardware configuration
2.2 IP ADDRESS CONFIGURATION
This device can be configured as a Bridge/Router or Access Point. The default IP address of the
device is 192.168.1.2 In order to log into this device, you must first configure the TCP/IP settings
of your PC/Notebook.
• In the control panel, double click Network Connections and then double click on the
connection of your Network Interface Card (NIC). You will then see the following screen.
WLAN Route
r
PC
Power Outlet
Ethernet
AC/DC cable
Ethernet
Cable / DSL
Modem