User manual

Basic Settings cont. - Section 17-B
You can begin and end a Data [Log] while in Basic Settings. See section 8 of this manual
for information on Data Logging.
For control modules that have a Label File with Basic Settings information, a drop-down
menu is available which allows you to select from the supported Basic Settings functions.
Below that menu is an area to display additional info for Basic Settings. The data to be
displayed in this area comes from the Label files and it may take some time before tips are
included for most Basic Settings groups.
As is the case for other functions under UDS, there are no longer any channel or group
numbers. Instead, the Basic Setting to be performed must be selected from a drop-down
list:
Dual ECU's: For vehicles with dual ECU's (like the Audi R8), the Basic Settings mode for
both ECU's can be accessed simultaneously by addressing [31 – Engine Other]
Warnings:
 You should refer to the Factory Repair Manual for your particular car (or some
other documented procedure) before "playing" with the Basic Settings function.
Failure to follow the proper procedures can result in serious damage to the
vehicle.
 Although you can use the [Up] and [Dn] buttons to scroll through the available
groups just like on the Measuring Blocks screen, this is NOT a good idea since
you may put the Controller into Basic Settings for a Group that you did not intend.