User manual

Recode cont. - Section 19-F
On some newer vehicles like the 8T0 (Audi B8 platform), the Gateway Installation is not
accessible via Long Coding. In such cases, use the [Installation List button in the Open
Controller screen for 19 - CAN Gateway to access this screen. This function is available in
all Gateways that support an Installation list:
If an uninitialized control module
warning appears, this means that
one or more of the WorkShop Code,
Importer, or Equipment numbers
are all zeros. Since some modules
will not allow you to Save Coding
values unless non-zero numbers
are in any or all of those fields,
VCDS shows you this error when it
thinks this might be the case. ►
In most cases you should click [Yes] to allow VCDS to enter 12345/123/12345 in those
fields. If you click [No] then VCDS will try using the values currently stored in the module
even if they are all zeros. If you click [Cancel] then VCDS will allow you to manually type in
values for each of those fields.
Use the [Do It!] button to save the new Soft Coding to the controller and return to the Open
Controller screen.
Use the [Cancel] button to return to the Open Controller screen without making changes.