User Manual

Switcher Sets
The switcher stores conguration and operation data in
a number of registers that contain the individual entries
for items such as memories or personality settings. These
registers can be stored as a single archive le, or as a
register set that contains all the individual register of that
type; all memories for example. These les are stored
into Sets on USB drive. Different Sets can be created for
different shows or applications, allowing you to quickly
locate and recall the switcher congurations.
The switcher stores information in the following registers:
• Memory — contains all the memories for ME,
MiniME
™
, and MultiScreen.
• Custom Control — contains all the custom control
banks and macros.
• Personality — contains all the user interface settings,
such as transition rates, that are stored under the
PERS menu. Some personality settings are specic
to the control panel and can be stored independently
if you are working with a MultiPanel system.
• Installation — contains all the external device setup,
and software settings for the switcher.
To Store a Set
Switcher Sets can only be stored to a USB drive. The
USB drive must be present before you try to store the
Set. A total of 10 Sets of switcher setup information can
be stored onto the same USB drive.
1.
Insert a USB drive into the USB Port on the
switcher. You must wait 5 seconds for the switcher
to recognise the USB drive.
2.
Press MENU > SAVE.
3.
Use the All knob to select the set (0-9) you want to
store the switcher registers to.
4.
Press the knob to select the registers you want to
store to the selected set. If an (*) is shown on the
menu, that register already exist in the set and will
be overwritten.
•
All — store all registers to the set.
•
Mems — store only the memory registers to the
set.
•
Cust — store only the custom control registers
to the set.
•
Inst — store only the installation registers to the
set.
•
PersX — store only the personality registers to
the set. Use the Pers knob to select whether to
include the personality setting for all panels
(PersA) or only the current panel (PersM/1/2).
5.
Press Confrm.
To Load a Set
Switcher Sets can only be loaded from a USB drive. The
USB drive must be present before you try to load the
settings.
1.
Insert your USB drive into the USB Port on the
switcher. You must wait 5 seconds for the switcher
to recognise the USB drive.
2.
Press MENU > LOAD.
3.
Use the All knob to select the set (0-9) you want to
load the switcher registers from.
4.
Press the selected set. Only registers with an (*)
shown on the menu exist in the set.
•
All — recall all registers from the set.
•
Mems — recall only the memory registers from
the set.
•
Cust — recall only the custom control registers
from the set.
•
Inst — recall only the installation registers from
the set.
•
Pers — recall only the personality registers from
the set. Use the Pers knob to select whether to
include the personality setting for all panels
(PersA) or only a specic panel (PersM/1/2).
5.
Press Confrm.
Carbonite Black Solo Operation Manual (v1.2) — Switcher Sets • 43