User manual

ADC-8733A User Manual (Iss. 02B) Menus • 4–13
A - Chroma Gain
This menu allows you to adjust the Chroma (CR and CB) portion of the output signal. The range
is 50% to 150%. This menu uses ballistics.
C - C
B
Gain
Use this menu to adjust the CB portion of the output signal. The range is 50% to 150%. This
menu uses ballistics.
E - Factory Defaults
This function allows you to return all controls to their default values except the Heads-Up
Display and Switch Access menu parameters.
F - Switch Access
The ADC-8733A can be monitored using DashBoard at any time while it is powered. To be able
to adjust its parameters the card has to be unlocked. On power-up the Edit Permission always
reverts to its default value of locked.
The ACCESS LED lights whenever the card is unlocked. The Switch Access function allows
you to lock or unlock user access to all adjustment parameters from the card-edge controls. The
“lock” function should be performed after installation to secure all settings, and to prevent
accidental setting changes.
Note the following rules:
• When access is locked, no adjustments can be made and the HUD is automatically turned
off. The ACCESS LED is off.
• When access is unlocked, adjustments can be made. The ACCESS LED is lit. The HUD
must be manually turned on again if needed.
Bank B Menus
This section summarizes the functions available on Bank B.
Table 4.10 Bank B Menu and Parameters Table
Menu
Select
Menu Parameters HUD Values
0
Bank Select
+
–
–
A
B
C
D
BANK
A
B
C
D
1
NTSC Setup
a
+
–
On
Off
SETUP
ON
OFF
2
--
3
Vertical Interval Blanking
m
+
–
Blank
Pass Through
VI BLANK
BLANK
PASS
4
Vertical Interval End
m
+
–
Increase
Decrease
VI END (##)