Product manual

2 Installing a Rear I/O Module
2-4 9032 PRODUCT MANUAL 9032-OM (V4.1)
Figure 2-1 Rear I/O Module Installation
9032 Rear I/O Modules
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9032.
Notes: • Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied
with removable screw terminal block adapters. For clarity, the adapters are
omitted in the drawings below.
• RM20-x Rear I/O Modules compatible only with 20-slot frames.
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
Note: Rear I/O Modules RM-9032-C, -D, -E, and -H occupy two
rear module slot mounting locations and use two captive
screws.
Rear I/O Module RM-9032-G occupies three rear module
slot mounting locations and uses three captive screws.
1
2